Binding & finishing
Drilling (hole punching)
Drilling punches round holes through a whole stack of printed paper in one pass, so the sheets fit a ring binder, a hanger or a spiral. Carmichael Printing offers drilling as one of its bindery services, for binders, handbooks and calendars.
- Serving Carmichael since 1965
- Most quotes within one business day
- Mon-Fri 9:00-4:30, one block off Fair Oaks Blvd

Key points
- Holes drilled through the whole stack in one pass
- Three-hole is the usual pattern for ring binders
- Used for handbooks, manuals, calendars and forms
- Hole position must stay clear of text
- Hole sizes and spacing are set to the binder
Sheets that are meant to live in a binder look wrong with ragged hand punching, and a stack of 200 sheets is no fun to punch by hand anyway. Drilling does the whole stack at once, with every hole in the same place on every page.
Common hole patterns
| Pattern | Typical use |
|---|---|
| Three holes on the long edge | Standard ring binders for letter-size sheets |
| One or two holes at the top | Wall calendars and hanging charts |
| A row of small holes | Preparation for coil binding |
How it is done
The stack is squared up and held firmly while a hollow drill bit passes through the full thickness. Because the holes are cut clean, they do not tear out when the sheets are turned, and each page lines up with the one beneath it. The holes can be set to your binder, so tell us what you plan to use.
What gets drilled
- Employee handbooks and policy binders
- Training materials for a classroom or a crew
- Calendars that hang from a nail
- Forms and checklists that live in a binder
- Pieces that will later be coil bound
File setup for drilled pages
Leave at least 3/4 inch on the drilled edge clear of text and images. On a two-sided page the holes are on the left edge of the front and the right edge of the back, so leave the inside margin clear on both sides. For a wall piece, drill after trimming, so the holes sit at an exact distance from the finished edge.
If you are not sure which pattern your binder uses, bring one into the shop and we will match it.
What to tell us for a drilling quote
Tell us the sheet size, the number of sheets in each set, the quantity of sets, and which binder or hanger the holes are for. Bring the binder if you can. Tell us which edge to drill and whether the covers should be drilled along with the pages.
Can you drill a job after it is printed and trimmed?
Yes. Drilling is normally the last step, done on the finished stack.
Can you drill heavy covers along with the pages?
Usually, yes. Tell us the covers and the page count so we know how thick the stack will be.
Start a job
Tell us about your print job.
Send what you know: the piece, the quantity, your file if you have one. Just tell Tony what you need.
(916) 487-8679Monday to Friday, 9:00 am to 4:30 pm. Or stop by 5757 Robertson Ave, Ste B, one block off Fair Oaks Blvd.
- Serving Carmichael since 1965
- Most quotes within one business day
- Mon-Fri 9:00-4:30, one block off Fair Oaks Blvd
